Fence Staining in Wichita, KS
Cedar and pressure-treated fences cleaned and sealed before the sun greys them out — sprayed and back-brushed so the stain is actually in the wood.
What fence staining looks like with us
A fence is the largest run of bare wood most properties have, and it takes the weather from both sides with no roof over it. Left unsealed, Kansas sun greys cedar within a season and the south and west runs start checking and cupping years before the shaded ones. We clean, repair and stain fences across the Wichita metro, and we do it in a way that accounts for the one thing every fence job here has to plan around: wind.
Every fence staining job is quoted after a free on-site visit, so the price reflects the condition of what is actually there rather than a guess made over the phone. The number in the quote is the whole number. Adam has been painting Wichita homes since 2011, and the siding work sits in the same crew — so where a coating is not the right answer, we can say so and still fix it.
What’s included
New pressure-treated fence? Wait.
This is the single most common fence-staining mistake in this area. New pressure-treated lumber arrives wet with treatment and won't take a penetrating stain until it has dried out — which takes months, not weeks, depending on when it went in and what the summer has done since. Stain applied too early sits on the surface, goes blotchy and peels. Cedar is more forgiving and can usually be sealed much sooner. If your fence is new, we'll tell you to wait rather than take the money and give you a finish that fails.
Wind decides how a fence gets coated
Wichita sits in one of the windiest metropolitan areas in the country, and a fence is a tall flat surface with a neighbor's property, cars and plants directly downwind of it. Spraying blind into that's how stain ends up somewhere it was never meant to be. We spray and back-brush — the spray lays the material on, the brush works it into the grain — and we work the sheltered runs on the days the wind won't behave. It's slower than spraying alone and it's the difference between a finish that soaked in and one that sat on top.
Which stain lasts on a fence
Unlike a deck, a fence is a vertical surface nobody walks on, which changes the answer. Solid and semi-solid stains last longest here and hide the color differences between original and replacement boards. Semi-transparent keeps the cedar grain visible and is the better-looking option on a newer fence, at the cost of more frequent recoating. Either way the south and west runs will always need attention before the rest, so it's worth planning the color around what those will look like in five years.
How the job runs
- 1Free on-site estimate
We measure the property and look at what is actually there, not a price guessed over the phone. For exteriors you don't even need to be home. - 2One number, in writing
You get the full price, what it covers and what it doesn't. No line items appearing later. - 3Prep, then paint
Booked within 7–10 business days. Protection down, surfaces made sound, and only then the coating — this is where the job is won or lost. - 4Walkthrough and clean-up
We tidy up daily and walk the finished job with you. Anything you aren't happy with gets put right.
Where we work
We take fence staining across Wichita and the surrounding metro — Derby, Andover, Maize, Goddard, Haysville, Valley Center, plus Bel Aire, Park City, Kechi, Colwich, Clearwater, Rose Hill, Mulvane and Augusta. Check your town or ZIP code, or request a free estimate.
Ready to price your fence staining?
Tell us about the job and we will set up a free estimate anywhere in the Wichita metro.